Publicité
Les langues disponibles
Les langues disponibles
8630972
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does
not function properly or parts are missing. If unable to do so,
have a qualified technician service the tool.
PROBLEM
Tool runs at normal
speed but loses
power under load.
Tool runs slowly.
Air flows slightly
from exhaust.
14
1/2 in. dr. Micro Stubby Air Impact Wrench
POSSIBLE CAUSE(S)
Motor parts worn.
Cam clutch is worn due
to lack of lubricant.
Motor parts jammed
with dirt particles.
For technical questions call 1-800-665-8685
SUGGESTED
SOLUTION(S)
Have a qualified
technician replace
worn parts.
1. Lubricate the
clutch housing.
2. Check for excess
clutch oil. Overfilling can
cause drag on high speed
clutch parts.
Grease lubrication note:
Heat usually indicates
insufficient grease in
chamber. Severe
operating conditions
may require more
frequent lubrication.
1. Check air inlet
filter for blockage.
2. Pour air tool lubricating
oil into the air inlet
as per instructions.
3. Operate the tool in
short bursts quickly
reversing rotation
back and forth
where applicable.
4. Repeat above as
needed. If this fails, return
to service centre.
V1.0
Publicité
