PRO-POINT 8630972 Manuel D'utilisateur page 13

V1.0
4. Oiling your air tool regularly is important, but also is
important not to OVER oil your air tool. Over oiling can
cause premature tool failure. Your tool may not be ruined,
but it will begin to experience loss of power that will
continually get worse until it no longer works. The tool then
has to be taken apart and cleaned of excess oil.
5. All air tools are packed in grease to prevent corrosion of
internal parts during shipping and storage. We recommend
that you clean this out to have optimum performance
from your new air tool. Use two drops of air tool oil to
lubricate the tool and run the tool under no load until
exhaust is clear.
6. In the event that it becomes necessary to store the tool
for an extended period of time (overnight, weekend, etc.),
it should receive a generous amount of lubrication at that
time. The tool should be run for approximately 30 seconds
to ensure oil has been evenly distributed throughout
the tool. The tool should be stored in a clean and
dry environment.
NOTICE! NEVER use a penetrating oil to lubricate the tool.
Penetrating oil may act as a solvent that will break down the
grease and cause the tool to seize up.
STORAGE
When not in use for an extended period, apply a thin coat of
lubricant to the steel parts to avoid rust. Remove the lubricant
before using the tool again.
DISPOSAL
Recycle a tool damaged beyond repair at the
appropriate facility.
Visit www.princessauto.com for more information
1/2 in. dr. Micro Stubby Air Impact Wrench 8630972
13