To Clean The Product; To Replace The Winch Cable; Storage; To Put The Product In Storage - Hamron 007058 Instructions D'utilisation

● If the product has been immersed in water it must be
disassembled, cleaned and lubricated. Speak to an
authorized service center.
● If you use a synthetic line on the product, replace it if you
notice the wear or damage that follow:
A. The thickness of the synthetic line has decreased
by 25% or more in any spot.
B. 2 or more adjacent strands of the synthetic line
are damaged.
C. There are flat sections or lumps that do not
disappear when the synthetic line is tensioned.
D. The fibers in the synthetic line have melted.

5.2 To clean the product

● Remove dirt and unwanted materials with a cloth.
● Pull out the winch cable and use a cloth clean it. Make
sure that the winch cable has tension when you wind it
up. Refer to "4.3 To tension the winch cable" on page
31.
Warning! Make sure that 5 turns of winch cable
remain on the winch cable drum.
Note! Coat the winch cable with non-viscous oil to prevent
rust.

5.3 To replace the winch cable

1
Put the clutch knob in the disengaged position.
2
Pull out the winch cable until it is in the end position.
3
Remove the winch cable.
4
Attach a new winch cable to the winch cable holder
on the winch cable drum.
Warning! Only use approved spare parts
recommended by the manufacturer.
5
Wind up the new winch cable to the winch cable
drum. Refer to "4.3 To tension the winch cable" on
page 31.
Caution! Make sure that the winch cable unwinds
from the lower part of the winch cable drum. If the winch
cable does not unwind from the lower part of the winch ca-
ble drum, the automatic load-holding brake will not operate
correctly. Information for the correct wind direction for the
winch cable is also given on a label on the product.
33
6

Storage

6.1 To put the product in storage

● Clean the product. Refer to "5.2 To clean the product" on
page 33.
● Turn the clutch knob to the engaged position.
7

Disposal

7.1 To discard the product

Make sure that you follow local regulations when you
discard the product. Do not burn the product.
8

Technical data

Technical data
Voltage
Output
Pulling power
Gear ratio
Protection rating
Winch cable diameter
Winch cable length
Weight
12 V (DC)
1 kW
1587 kg
136:1
IP55
Ø 5.5 mm
10.5 m
8 kg
2022_001