audisse shirudo Mode D'emploi page 16

ANSWERING INCOMING PHONE CALL
The Hands Free Calling feature allows you to answer an incoming phone call when the
sound system has been connecting to a Bluetooth mobile phone.
Press the Tuning/Seek/Select control (Phone icon) on the right to pick up an incoming
call.
Speak towards the microphone (MIC) located bottom side of the radio.
Adjust the conversation volume by rotating the Volume control. A lower volume setting
can reduce a possible echo in the phone conversation.
Press the Tuning/Seek/Select control again to hang up the phone call.
Note: The volume of ring tone will be increased to maximum after the phone rings for
about 10 seconds.
Note: The ringtone of iPhone will be streamed to the radio via Bluetooth. But because of
Android system, the ringtone of Android phone or other phones will only be sounded on
the mobile.
AUX INPUT
WARNING: Never use the AUX-IN socket in rainy or moist conditions to prevent
moist from entering the radio. Keep the rubber cover well closed under these
conditions.
A 3.5mm Auxiliary Input socket located on the rear of Audisse Shirudo is provided
for connecting the audio signal from an external audio source such as an MP3 or CD
player.
Connect a stereo lead from the headphone output of your MP3 or CD player to the Aux
In socket located at the rear of the sound system. Typically this lead will have a 3.5mm
stereo plug at both ends.
Switch on Audisse Shirudo by pressing the Power button briefly.
29
Press the Source button until AUX in mode is shown on the display.
Press the 'play' on the connected audio device. If you are using its headphone output for
the connection, set its volume control to a level of somewhere between two-thirds and
maximum (the objective is to get a strong audio signal but without too much distortion).
Then adjust the volume on the sound system as required. Note, if using an iPod as the
sound source, you may need to set its output to maximum to get an adequate audio
signal level.
After use, disconnect your player in order to listen to Audisse Shirudo conventionally.
EQUALIZER FUNCTION
The sound on Audisse Shirudo can be adjusted to suit your personal taste for the
material that you are listening to. The Audisse Shirudo has a range of equaliser modes.
Alternatively you may set the treble and bass levels to your own preferences which can
be accessed from the My EQ menu item.
Press the Power button to switch on your radio. Access the menu for the current mode
by pressing the Menu button.
Rotate the Tuning/Seek/Select control until 'System settings' is highlighted on the
display. Press the control to enter the system settings menu.
GB
30