audisse shirudo Mode D'emploi page 14

To find more FM stations press the Tuning/Seek/Select control to repeat the scan
operation. To scan down in frequency, rotate the Tuning/Seek/Select control in a anti-
clockwise direction first and then press the control. Your radio will scan down the FM
band from the currently displayed frequency and will stop scanning when it finds a signal
of sufficient strength.
When the end of the waveband is reached Audisse Shirudo will recommence tuning
from the opposite end of the waveband.
Use the Volume control to adjust the sound level as needed.
PRESETTING RADIOSTATIONS
There are 40 memorypresets. They are used in the same way for each operating mode.
The Audisse Shirudo has the unique function of Preset + and Preset –
This enables you to quickly zap through your whole preset list.
When performing a Factory Reset the whole Preset memory of the radio will be emptied.
To store radio stations into 40 memory presets by using Preset button.
Press the Power button to switch on Audisse Shirudo.
Tune to the required radio station as previously described.
To store the station as a preset station, press and hold the Preset button until the
display shows a preset menu 'Save to Preset'.
Rotate the Tuning/Seek/Select control to the desired preset number until it is
highlighted. Press the Tuning/Seek/Select control to confirm and the display shows
'Preset Stored'. The station will be stored under the chosen preset button. Repeat this
procedure as needed for the remaining presets.
Stations which are already stored in the presets may be over written by following the
above procedure.
Note: The radio station presets are retained in memory when the sound system is
switched off and disconnected from the mains supply.
25
Recalling a preset radiostation
Press the Power button to switch on Audisse Shirudo.
Select the required operating mode using the Source button.
You can briefly press the Preset -/Skip Backward button to recall the previous one
preset station. For example, if you are playing P2, the Preset -/Skip Backward button
will recall the P1 station if it exists.
Note: If the P1 station is not existing in the preset menu, the sound system will directly
search for the previous available station in the list, then play.
Note: If there is no available station in the preset list, the sound system will display a
pop-up screen with an announcement "Preset empty".
or you can briefly press the Preset +/Skip Forward button to recall the next one preset
station in the list. For example, if you are playing
P2, the Preset +/Skip Forward button will recall the P3 station if it exists.
Note: If the P3 station is not existing in the preset menu, the sound system will directly
search for the next available station in the list, then play.
Note: If there is no available station in the preset list, the sound system will display a
pop-up screen with an announcement "Preset empty".
Or press and release the Preset button until the display shows the "Recall from Preset"
screen.
Use the Tuning/Seek/Select control to scroll through the preset list until you reach the
preset you want to select. Press and release the Tuning/Seek/Select control to select
the preset.
GB
26