audisse shirudo Mode D'emploi page 12

USB PLAYER
Using USB memory devices
This section describes how to use your radio to access and playback your audio files via
USB memory devices.
USB memory devices plug into the rectangular slot on the top of your radio on the left
hand side.
Important: Your radio is only designed to work with USB flash memory devices. It is not
intended to be connected to hard disk drives or any other type of USB device.
The Shirudo radio has been tested with a range of USB memory devices of up to 128GB
capacity. USB memory must use the FAT or FAT 32 filing system in order to operate with
your radio. Your radio is unable to play from media formatted using the exFAT or NTFS
formats.
It is possible to use SD or SDHC cards for media storage and playback when held in
a suitable USB adaptor. However, due to the wide variation of such adaptors, it is not
possible to guarantee that all adaptor / card combinations will work in the radio.
Audio formats supported are MP3, WMA, AAC, FLAC and WAV. USB playback does not
support files encoded using WMA Lossless, WMA Voice, WMA 10 Professional, nor files
of any format, which have DRM protection.
DAB+ DIGITAL RADIO
DAB Radio
Using DAB mode for the first time
Carefully extend the telescopic aerial.
Please make sure the antenna does not make contact with the metal handle. This
influences the reception level.
Press the Power button to switch on the sound system. If the sound system has been
used before the last used mode will be selected.
Press the Source button as needed so that DAB radio mode is selected on the display.
21
If this is the first time, the display will show 'Scanning'. (If the sound system has been
used before the last used station will be selected instead.)
During the scanning process, as new stations are detected the station counter will
increase and the stations will be added to the list which is stored in the sound system.
The bar graph indicates the progress of the scan.
When scanning is completed the radio will list the stations found (in numeric-alpha order
0....9...A...Z), unless it has previously been tuned to a DAB station.
Rotate the Tuning/Seek/Select control to scroll through the list of available DAB radio
stations.
Press the Tuning/Seek/Select control to select the highlighted station. The display may
show 'Connecting...' while the radio re-tunes.
Use the Volume control to set the sound level as needed.
If the station list is still empty after the scan the display will show 'Service not available'.
If no stations are found it may be necessary to relocate Audisse Shirudo to a position
giving better reception.
GB
22