audisse shirudo Mode D'emploi page 13

Selecting a DAB radio station
When playing a DAB radio station, the display normally shows the name of the current
station with other related information.
Rotate the Tuning/Seek/Select control to access the radio station list and to scroll
through the available stations.
Press the Tuning/Seek/Select control to select the highlighted station. The display may
show 'Connecting...' while the radio re-tunes.
Use the Volume control to set the sound level as needed.
Note: If the display shows 'Station Not Available' it may be necessary to relocate
Audisse Shirudo to a position giving better reception.
A question mark in front of the station name merely indicates that the station has not
recently been detected by the sound system. It may still be available.
23
FM RADIO
Operating in FM mode
Carefully adjust the rod antenna and press the Power button to switch on Audisse
Shirudo.
Press the Source button as needed to select FM radio mode.
Rotate the Tuning/Seek/Select control in a clockwise direction. The displayed
frequency will increase. Press the Tuning/Seek/Select control to carry out an auto-
tune. Your radio will scan up the FM band from the currently displayed frequency and
will stop scanning when it finds a station of sufficient strength.
The display will show the frequency of the signal which has been found. If RDS
information is available, after a few seconds the display will show the radio station name.
If you only hear hiss or interference, simply press the Tuning/Seek/Select control to
scan further. Audisse Shirudo may have found a spurious interference signal.
GB
24