DrBrowns SoftShape Manuel D'instructions page 2

PARTS DIAGRAM
A. Collection Bottle
B. Bottle Adapter
C. Valve
D. Connector
E. Breastcup
F. Cap Insert
G. Cap
H. Handle
2
TABLE OF CONTENTS
Parts Diagram
Disassembly
Cleaning
Assembly -
Expressing Breastmilk -
Storing & Handling Breastmilk
Thawing & Preparing Breastmilk
Tips
Troubleshooting
DISASSEMBLY
Loosen and remove Bottle from Adapter.
Loosen and remove Adapter from Connector.
Remove the white Valve from underneath
the Connector.
Remove Breastcup by gently pulling on the
perimeter tabs.
CLEANING
Before your first use and after all other uses, it is
important to wash your pump.
Make sure all pump parts have been disassembled
for cleaning.
All pump parts can be hand-washed or washed in
a dishwasher.
Note: The white Valve and Breastcup are delicate. Please take extra care in cleaning them. It is recommended that you
hand wash these parts. Do not use any rough brushes to clean these parts.
ASSEMBLY
After cleaning, follow these steps to assemble your pump. Make sure all parts are completely dry from
cleaning before any assembly.
Insert the white Valve to the Screw on the Bottle Adapter.
underside of the Connector. Tighten gently.
Snap the Breastcup on to the Install Cap Insert on to the Cap,
Connector. Press edges firmly to aligning the two pegs in the holes.
make sure it's secure all around. Press the parts firmly together.
Remove Cap assembly by pulling up on
the Cap tab at the back of the pump.
Remove Handle by pushing the stem of the
Cap Insert upward, then unhinging to separate.
Remove Cap Insert from Cap by pulling down.
TO HAND WASH: Wash all parts in
warm, soapy water, rinse well and air dry.
IN DISHWASHER: All pump parts are
top-rack dishwasher safe. Completely air
dry parts and let them cool.
Screw the Bottle to the Bottle
Adapter. Tighten gently.
Attach Handle by pressing
upward on the Cap Insert to
extend the stem.
3