Assembly Instructions - Dyna-Glo DGU951SSE Mode D'emploi

ASSEMBLY INSTRUCTIONS

1. Remove the eight pre-installed M5 x 12 (CC)
screws from the bottom of the cabinet assembly
(A) and attach each of the rear casters (B) us-
ing four screws per caster. Remove the six pre-
installed M6 x 12 (BB) screws from the bottom of
the cabinet assembly and attach the front legs (C)
using three screws per leg.
Hardware (Pre-installed)
M6 x 12 mm
BB
Screw
M5 x 12 mm
CC
Screw
2. CAUTION: This unit is HEAVY! Do not attempt
this step without assistance!
With the assistance of a helper, stand the smoker
upright on a firm and level surface. (Make
sure that legs and casters are firmly attached).
Remove the four pre-installed M5 x 12 (CC)
screws from the back of the cabinet assembly (A)
and attach the rear handle (D).
Hardware Used
M5 x 12 mm
CC
Screw
1
x 6
x 8
2
x 4
10
BB
A
CC
B
BB
C
CC
D
A