Assembly Instructions - Dyna-Glo DGU732SDE Mode D'emploi

ASSEMBLY INSTRUCTIONS

1. Remove the 4 pre-assembled M4 x 35 mm screws
(BB) from the door handle (E) and attach the door
handle (E) on the upper door assembly (C) as
shown. Tighten the screws.
Hardware Used
M4 x 35 mm
BB
Screw
2. Remove the 2 pre-assembled M5 x 12 mm screws
(AA) from the smoker cabinet assembly (A). Insert
the 2 screws into the rear handle (B), and into the
threaded holes on the back of the smoker cabinet
assembly (A). Tighten the screws.
Hardware Used
M5 x 12 mm
AA
Screw
1
x 4
2
x 2
10
BB
A
C
E
B
AA