Publicité
Les langues disponibles
Les langues disponibles
7.0 Power Unit and Motors
Never place your hands or any other part of your body over the end of
the suction hose or inlet spigot while the BIG MIKE is in operation. The
powerful suction could cause injury.
7.1 Power Unit
7.2 The motors are housed inside the metal box on top of the lid. In order to safely maintain the power
unit and its motors see the Safety Instructions and Grounding Notes.
The power unit contains 3 motors that can be switched on or off one at a time.
7.3 Switching On The Motors
The BIG MIKE has a 4-position switch which switches each motor on and off individually. Position 0 is
off. Position 1 switches the first motor on; Position 2 switches the second motor on; Position 3
switches the third motor on. This is known as a "soft start" and prevents surges on your power supply.
Always switch all three motors on before using the BIG MIKE to clean up.
Never operate the BIG MIKE with just 1 or 2 motors running.
7.4 Thermal Cut-Outs
The motors are fitted with overheat protection thermal cut out units. If the motors cannot cool
themselves adequately, the thermal cut-outs will automatically shut the motors down to protect them.
This can occur if the flow of air up the suction pipe is very hot, or the flow is obstructed in the pipe or
the drum is full.
If the thermal cut-outs shut the motors down, turn the power switch to Position 0 and unplug the
appliance from the power supply. The thermal cut-outs will automatically allow the motors to restart
once they have cooled sufficiently.
NEVER leave an overheated appliance connected to the electrical supply
with the power switch at Position 1, 2 or 3. Always switch the power
switch to Position 0 and unplug the appliance from the power supply.
This will prevent the appliance restarting itself in your absence once the
motors have cooled sufficiently.
18
Danger
4-position switch for turning on the motors
Caution
Warning
Publicité
