Publicité
Les langues disponibles
Les langues disponibles
6.1.6 If the BIG MIKE has been used without the Primary Filters in place
If the BIG MIKE has been used in Dry Mode without the Primary Filters in place, switch off the BIG
MIKE immediately.
Examine the Primary Filters thoroughly to ensure they are clean and in good order.
Refit both Primary Filters before using your BIG MIKE again.
Be aware that the motors may have been damaged. If you suspect any motor damage has occured
(e.g. adverse noises or smells from the motors or any reduction in performance) switch off the BIG
MIKE immediately and do not use. Contact your distributor for further advice.
6.2 Filters for Wet Use
Never use the V39 Primary Filters when operating in Wet Mode.
The Overfill Protection Float must be fitted before using the BIG MIKE Leapfrog Wet & Dry in wet
mode.
Before fitting the Overfill Protection Float, check that:
•
the perforations in the Overfill Protection Float are clean, undamaged and aren't blocked
•
the rubber gasket is fitted to the rim of the Overfill Protection Float and that it is in good
condition.
•
the ball float inside the Overfill Protection Float is free to move up and down.
Do not use if the Overfill Protection Float shows any signs of damage.
6.2.1 Indication that your Collection Drum is full
As the level of the liquid inside your collection drum rises, the ball float inside the Overfill Protection
Float rises. When the liquid inside your collection drum reaches its maximum value, the Overfill Protec-
tion Float will automatically cut off the airflow from the power unit.
You will know when this happens as the suction of liquid will suddenly stop and the motor noise will
16
Caution
Overfill Protection Float for use in wet mode
Publicité
