BIG MIKE 120V Mode D'emploi page 15

Fit the Primary Filters inside the
top of the Leapfrog Drum.
6.1.3 Cleaning the Primary Filters
Clean the Primary Filters regularly and each time the drum is emptied. The Primary Filters can be
cleaned by shaking them. Remove the power unit from the top of the Leapfrog Drum but leave the
suction hose in place to prevent dust escaping from the drum.
Clean the Primary Filters by grasping the shaking-handle sewn onto the filter and shaking it up and
down to dislodge any dust and dirt on the underside. Remove the uppermost Primary Filter and repeat
for the lower Primary Filter.
To clean the Primary Filters more thoroughly, shake them clean as above and carefully remove them.
We recommend vacuuming the filters clean (additional Primary Filters can be purchased for this
purpose) or by beating them clean in a suitable area out of doors.
Caution
Never wash the Primary Filters as this will destroy them.
6.1.4 Checking the Primary Filters for Damage
Always inspect the Primary Filters for damage each time you clean them. Ensure they are free of holes
and show no signs of damage or wear.
If you've any doubt about the state of your Primary Filters, please replace them.
6.1.5 If the Primary Filters Get Wet
The Primary Filters are intended only for use in dry mode. Never use the Primary Filters in wet mode.
If the Primary Filters do get wet, clean them by shaking as described above. Carefully remove the
filters and allow them to naturally air dry. Vacuum or beat the filters clean and refit them before using
the BIG MIKE in dry mode again.
Warning
Always ensure the Primary Filters are dry before using in the BIG MIKE.
15