BIG MIKE 120V Mode D'emploi page 14

6.0 Filters
6.1 Filters for Dry Use
The BIG MIKE Leapfrog Wet & Dry is supplied with two V39 Primary Filters for dry use. Always use
both Primary Filters together, one fitted inside the other.
Never operate the BIG MIKE with damaged filters. If in doubt, replace the
filter.
6.1.1 The Primary Filters
The Primary Filters keep dirt and dust out of the power unit and its motors. Waste material sucked up
is deposited inside the drum. The air and fine dust it contains then passes through the two Primary
Filters, which filter out the remaining fine dust. The filtered air then passes through the turbines and
then through the motors to cool them.
V39 Standard Primary Filter
Ensure that both Primary Filters are fitted with the fabric shaking-handle
(sewn inside the filter) and the writing uppermost. Failure to do so will
result in poor filtration.
6.1.2 Fitting the Primary Filters
Never operate the BIG MIKE Leapfrog Wet & Dry without both Primary
Filters in place.
The Primary Filters fit inside the top of Leapfrog Drum. Make sure the Primary Filters aren't inside out
- they're designed to work only one way. Fit the Primary Filters so that the writing and the shaking-
handle (sewn onto the filter) are uppermost.
Fold the elasticated edge of the filter over the rim of the drum. Ensure that the filter covers the rim of
the drum all the way round. Ensure that the filter extends 2" (50mm) down the outside of the drum.
Fit the second Primary Filter inside the first and fold over the top of the drum as above.
If, whilst using the BIG MIKE in Dry Mode, you notice the Primary Filters aren't in place, switch the
BIG MIKE off immediately. Refer to the section "If the BIG MIKE has been used without the Primary
Filters in place".
14
Caution
Approx.
13"
330mm
V39 Standard Primary Filter
Caution
Caution
Filter Shaker Handle