DeWalt DCF894 Guide D'utilisation page 60

NOTE: This tool has been tested at the factory, which may result in a
small amount of grease left in the grease tube and hose assembly. It is
recommended to purge the tool with the brand of grease to be used
before fi rst use.
OPERATION
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. 10)
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (P) into the tool handle, align the battery
pack with the rails inside the tool's handle and slide it into the handle
until the battery pack is fi rmly seated in the tool and ensure that it does
not disengage.
To remove the battery pack from the tool, press the release button (Q)
and fi rmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
FIG. 10
P
FUEL GAUGE BATTERY PACKS (FIG. 11)
Some D WALT battery packs include a
E
fuel gauge which consists of three green
LED lights that indicate the level of charge
remaining in the battery pack.
To actuate the fuel gauge, press and hold
the fuel gauge button (FF). A combination
of the three green LED lights will illuminate
designating the level of charge left. When
the level of charge in the battery is below
the usable limit, the fuel gauge will not
illuminate and the battery will need to be
recharged.
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate tool functionality and is subject to
variation based on product components, temperature and end-user
application.
For more information regarding fuel gauge battery packs, please call
1-800-4-D WALT (1-800-433-9258) or visit our website www.dewalt.
E
com.
Using the Grease Gun (Fig. 2)
WARNING: To reduce the risk of serious personal injury,
always maintain a grip on the handle (C) when operating the
Q
grease gun or positioning the hose onto fi ttings.
To operate the grease gun, hold the grease gun by the handle (C), or
place it on a stable surface upright on its rubber feet (R) maintaining
a grip on the handle. Holding the hose by the fl exible hose safety
spring guard (H), connect the fl exible hose grease coupler (I) or other
appropriate grease coupler, onto the grease fi tting to be fi lled. Carefully
depress the variable speed trigger switch to begin the fi lling process.
Once the correct amount of grease has been dispensed, release the
14
FIG. 11
FF