INSTALLING IB500 IN FRONT OF THE HOOD,
WHEN VENTING TO THE BACK
- When venting to the rear with the IB500
blower mounted on the front of the unit, some
modification to the blower box is required
(FIGURE 16)
- Loosen the two screws holding the blower in
the box. Take the blower out of the box
FIGURE 16
- Remove the small cover on the back of the
hood (FIGURE 17)
- Mount the blower on the front of the hood using
two screws while positioning the vent collar in
the opening of the cover (FIGURE 18)
FIGURE 18
PRODUCT INSTALLATION
- Plug the wiring cable from the hood into the
blower (FIGURE 19)
- Remove the vent collar from the blower box and
close the opening in the blower with the cover
removed from the back of the hood housing
removed from FIGURE 17. Attach it with 4
screws. (FIGURE 20).
- Mount the vent collar on the back of the hood
(FIGURE 21)
- Mount the blower box to the housing with 4
screws (FIGURE 22)
Continue to Page 14 for Electrical
Connections
FIGURE 17
FIGURE 19
FIGURE 22
FIGURE 20
FIGURE 21
Version 6/12 - Page 13