Turbo Mode; Valet Mode (Via Remote) - Fortin FSA-211 Guide Utilisateur

TURBO MODE

Turbo Mode (if installed) is similar to Idle Mode but is used to cool down the turbo-charger once the
driver leaves the vehicle. The Remote-Starter will continue run the vehicle for 2 minutes allowing the
turbo-charger to cool down.
TURBO MODE (AUTOMATIC TRANSMISSION)
To activate Turbo Mode (automatic transmission) proceed with the following steps:
STEP 1
STEP 2
STEP 3
STEP 4
TURBO MODE (MANUAL TRANSMISSION)
Turbo Mode (if installed) is similar to Idle Mode but is used to cool down the turbo-charger once
the driver leaves the vehicle. The Remote-Starter will continue run the vehicle for 2 minutes
allowing the turbo-charger to cool down. To activate Turbo Mode (manual transmission) proceed
with the following steps:
IDLE MODE (MANUAL TRANSMISSION)
See

VALET MODE (VIA REMOTE)

Valet Mode disables the remote-starter and security system.
is being serviced or repaired, or the vehicle is parked indoors it is mandatory that Valet
Mode be enabled to prevent an accidental Remote-Start.
Note: The security system is deactivated (including Starter Kill) when the system is in Valet Mode.
However you are still able to lock & unlock the doors, use the auxiliary and release the rear
hatch/trunk. This method of enabling/disabling Valet Mode uses the remote transmitter instead of
the valet switch indicated in the preceding section.
To enter Valet Mode using the remote transmitter proceed with the following steps:
STEP 1
STEP 2
To exit Valet Mode using the remote transmitter proceed with the following steps:
STEP 1
STEP 2
With the engine already running, push the START button until
the parking lights come on.
Remove the key from the ignition barrel.
The vehicle will continue to run with the the Remote-Starter.
Exit the vehicle and close all of the doors.
The vehicle will continue to run after all the doors are closed.
Press the LOCK button to lock the doors.
The vehicle will continue to run for 60 seconds
page 7.
See 2-WAY OLED REMOTE (page 2) or 1-WAY REMOTE
(page 5).
The parking lights will flash once.
The LED will turn ON solid and remain ON. (if installed)
See 2-WAY OLED REMOTE (page 2) or 1-WAY REMOTE
(page 5).
The parking lights will flash once.
The LED will turn OFF or will start to flash. (if installed)
8
IMPORTANT Whenever the vehicle