Cold Start Timer Mode; Auxiliary Use; Remote Starting Options; Configurable Fonctionality During Installation - Fortin FSA-211 Guide Utilisateur

COLD START TIMER MODE

Cold Start Timer Mode will remote-start the vehicle every 1.5 or 3 hours and run for 3, 5, 7 or 15
minutes (6, 14 or 30 for diesel engines), depending on programming. The remote-starter will repeat
this sequence for up to a maximum of 24 hours. For manual transmission vehicle's READY MODE
must be enabled, and if at any time READY MODE is disabled this sequence will cancel.
WARNING Do not start the vehicle indoors (garage, underground parking).
To enable Cold Start Timer Mode
See 2-WAY OLED REMOTE (page 2) or 1-WAY REMOTE (page 5).
To disable Cold Start Timer Mode do any of the following:
• See 2-WAY OLED REMOTE (page 2) or 1-WAY REMOTE (page 4).
• Put the Remote-Starter/Security-System into Valet Mode.
• Remote-Start the vehicle.
• Open the hood.
• Press the brake pedal.
• Turn the key to the ignition (ON / RUN) position.
• Disable Ready Mode (manual transmission).
Note: If the Alarm is triggered during Remote-Start (Cold Start), the vehicle will stop running, but Cold
Start will not cancel its schedule.

AUXILIARY USE

The function of the auxiliary outputs may vary depending on the vehicle and the installation. In most
cases these outputs are not used, and in some cases they may be used to control other features such
as the sliding door, power windows, sunroof, or heated seats. Check with the installer to find out what
AUX outputs have been installed, and what they control.
See 2-WAY OLED REMOTE (page 2) or 1-WAY REMOTE (page 5).

REMOTE STARTING OPTIONS

CONFIGURABLE FONCTIONALITY DURING INSTALLATION

This Remote-Starter is designed to be highly flexible when integrating into original equipment (OEM).
With the following programmable options the Remote-Starter/Security-System can control most
electronic systems within the vehicle.
WARNING: This Remote-Starter must be installed by a trained professional. Improper
modifications to any of the following settings could adversely affect the reliability of the Remote-Starter
and/or the vehicle's operation.
Configurable Options: :
● Remote Door Locks
● Security Lock
● Runtime Reset

REMOTE DOOR LOCKS

If the Remote-Starter is installed with door locks, you will be able to lock and unlock the vehicle without
using the key or OEM key fob.
To UNLOCK the doors and DISARM the security:
Press the UNLOCK button for 1 second.
The parking lights will flash twice and the LED (if installed) will turn OFF to confirm the signal. The
Starter-Kill will also deactivate allowing the vehicle to be started with the key. If UNLOCK is pressed
again (consecutively) the horn will honk twice (if installed) to confirm.
● Active or Passive Arming
● Trunk/Hatch Release
● Secure Transmitter Mode
10
● Ignition Door Locks
● Runtime