Remote-Starter Feature's; Idle Mode (Automatic Transmission); Idle Mode (Manual Transmission) - Fortin FSA-211 Guide Utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

REMOTE-STARTER FEATURE'S

IDLE MODE (AUTOMATIC TRANSMISSION)

Idle Mode allows the vehicle to run without the key in the ignition barrel. For example, if you stop for a
quick errand or delivery, simply allow the vehicle to run while you are gone. The engine will run until the
Remote-Starter runtime expires. Press START any time the vehicle is running with the Remote-Starter
to reset this timer. To activate Idle Mode (automatic transmission) proceed with the following steps:
STEP 1
STEP 2
STEP 3
WARNING : Never leave children or animals in a Remote-Started vehicle unattended.

IDLE MODE (MANUAL TRANSMISSION)

Idle mode is activated in much the same way Ready Mode is activated, except for Step 1. To activate
Idle Mode (manual transmission) proceed with the following steps:
IDLE MODE ACTIVATION:
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
The engine will continue to run until either the transmitter (STOP) button is pressed, the Remote-
Starter runtime expires, the parking brake is disengaged, the brake is pressed, or the hood is opened.
If the Remote-Starter is shut down by transmitter it will automatically go in to Ready Mode (if all the
doors are closed).
WARNING : Never leave children or animals in a Remote-Started vehicle unattended.
With the key in the barrel at the ignition (ON/RUN) position
and the engine running, press the START button, until the
parking lights turn on.
Turn the key to the OFF position and remove the key from
the ignition barrel. The vehicle will continue to run with the
the Remote-Starter.
Get out of the vehicle and press the LOCK button to lock
the doors. The engine will run until the Remote–Starter
runtime expires.
Open at least one door and ensure the transmission is in
and
the NEUTRAL position.
 
 
Engage the parking brake.
Release the brake pedal.
Within 20 seconds push the START button.
The parking lights will flash once and then remain on.
Remove the key from the ignition barrel.
The vehicle will continue to run with the the Remote-Starter.
Exit the vehicle and close all of the doors.
The vehicle will continue to run after all the doors are closed.
Lock the doors by pushing the LOCK button.
7
 
 

Publicité

Chapitres

Table des Matières
loading

Table des Matières