Valet Mode (Via Switch) / Valet Coding - Fortin FSA-211 Guide Utilisateur

VALET MODE (VIA SWITCH) / VALET CODING

Valet Mode disables both the Remote-Starter and Security-System. Whenever the vehicle is being
serviced or repaired, or the vehicle is parked indoors it is mandatory that Valet Mode be enabled to
prevent an accidental Remote-Start.
Note: The security system is not active (including Starter Kill) when the system is in Valet Mode.
However you are still able to lock and unlock the doors, and release the rear hatch/trunk.
Note: When the Remote-Starter/Security-System is in Valet Mode, the LED will stay ON solid instead
of flashing after the doors are locked. The LED (if installed) will turn off only after Valet Mode is
disabled.
The valet mode can be programmed to use a coded entry in order to increase the security of your
system and to prevent accidents. By default, the valet button is pressed 3 times after turning the
ignition. Function 30 can be programmed to use a coded value instead of the default one.
VALET CODING DISBALED (DEFAULT):
To activate and deactivate Valet Mode using the valet switch proceed with the following
steps:
STEP 1
STEP 2
STEP 3
VALET CODING ENABLED (OPTIONAL):
To activate and deactivate Valet Mode using the valet switch proceed with the following steps:
STEP 1
STEP 2
STEP 3
STEP 4
Note: The coded valet option allows a selection of one of the five available codes. Once the
installer chooses one of the codes, note the value here so you do not forget
it_____________________.
Insert the key and turn it to the ignition (ON/RUN) position.
The vehicle does not need to be started.
Within 10 seconds press (1 second) and release the Valet
switch 3 times.
Valet mode enabled: The LED is ON
Valet mode disabled: The LED is OFF (if installed)
Insert the key and turn it to the ignition (ON/RUN) position.
The vehicle does not need to be started.
Within 10 seconds press and release the valet button 3 to 7
times (X = valet code) for 1 second. If your valet code is 7 then
press and release the valet button 7 times.
Press and hold the valet button once for 3 seconds to finish
the sequence.
Valet mode enabled:The LED is ON
Valet mode disabled: The LED is OFF (if installed)
9