Turbo Mode (Manual Transmission); Valet Mode (Via Switch); Valet Coding Disabled (Default); Valet Mode (Via Remote) - Fortin RM441 Mode D'emploi

STEP 3
STEP 4

TURBO MODE (MANUAL TRANSMISSION)

Turbo Mode (if installed) is similar to Idle Mode but is used to cool down the turbo-charger once the
driver leaves the vehicle. The Remote-Starter will continue run the vehicle for 2 minutes allowing
the turbo-charger to cool down. To activate Turbo Mode (manual transmission, see IDLE MODE
(MANUAL TRANSMISSION) on page 10.
V ALET MODE (VIA SWITCH)
Valet Mode disables both the Remote-Starter and Alarm system. Whenever the vehicle is
being serviced or repaired, or the vehicle is parked indoors it is mandatory that Valet Mode be
enabled to prevent an accidental Remote-Start.
Note : The alarm system is not active (including Starter Kill) when the system is in Valet Mode.
However you are still able to lock and unlock the doors, and release the rear hatch/trunk.
Note : When the Remote-Starter/Alarm is in Valet Mode, the LED will stay ON solid instead of
fl ashing after the doors are locked. The LED will turn off only after the Remote-Starter/Alarm exit
Valet Mode.

VALET CODING DISABLED (DEFAULT)

To activate and deactivate Valet Mode using the valet switch proceed with the following steps :
STEP 1
STEP 2
3X
STEP 3

VALET MODE (VIA REMOTE)

Valet Mode disables the remote-starter and alarm. Whenever the vehicle is being serviced or
repaired, or the vehicle is parked indoors it is mandatory that Valet Mode be enabled to prevent an
accidental Remote-Start.
Note : The alarm system is deactivated (including Starter Kill) when the system is in Valet Mode.
However you are still able to lock & unlock the doors, and release the rear hatch/trunk. This method
of enabling/disabling Valet Mode uses the remote transmitter instead of the valet switch indicated
in the preceding section.
To enter Valet Mode using the remote transmitter proceed with the following steps :
Exit the vehicle and close all of the doors.
The vehicle will continue to run after all the doors are closed.
Press the LOCK button to lock the doors. The vehicle will continue
to run for 60 seconds.
Insert the key and turn it to the ignition (ON/RUN) position. The
vehicle does not need to be started.
Within 10 seconds press and release the button on the antenna
3 times.
Valet mode enabled : The LED is ON
Valet mode disabled : The LED is OFF
Page 12 / 19