Turbo Mode (Automatic Transmission) - Fortin RM441 Mode D'emploi

IDLE MODE ACTIVATION :
The vehicle must be running.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
The engine will continue to run until either the remote stop function is pressed (see FULL
FUNCTIONS, page 6), the Remote-Starter runtime expires, the parking brake is disengaged,
the brake is pressed, or the hood is opened. If the Remote-Starter is shut down by transmitter it
will automatically go in to Ready Mode (if all the doors are closed).
WARNING :
NEVER LEAVE CHILDREN OR ANIMALS IN A REMOTE-STARTED VEHICLE UNATTENDED.

TURBO MODE (AUTOMATIC TRANSMISSION)

Turbo Mode (if installed) is similar to Idle Mode but is used to cool down the turbo-charger once the
driver leaves the vehicle. The Remote-Starter will continue run the vehicle for 2 minutes allowing
the turbo-charger to cool down.
To activate Turbo Mode (automatic transmission) proceed with the following steps :
STEP 1
STEP 2
Ensure the transmission is in the NEUTRAL position.
Open at least one door.
While the engine is running, engage the parking brake.
Release the brake pedal.
Press the remote START button. The parking lights will fl ash once
and then remain on.
Remove the key from the ignition barrel. The vehicle will continue
to run with the the Remote-Starter.
Exit the vehicle and close all of the doors. The vehicle will continue
to run after all the doors are closed.
Remote-stop the vehicle.
With the engine already running, press the remote START button
until the parking lights come on.
Remove the key from the ignition barrel.
The vehicle will continue to run with the the Remote-Starter.
Page 11 / 19