Fortin RM441 Mode D'emploi page 9

METHOD 1 - programmed by default this method will activate the remote car starter sequence only
when the end user is using the remote car starter remote :
The vehicle must be running.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
METHOD 2 - This method must be programmed by the installer during installation. This method
will activate the remote starter sequence everytime the end user is leaving the vehicle. automatic.
ACTIVATION :
The vehicle must be running.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
The vehicle is ready to start. Open any door to cancel Ready Mode and start over the sequence
from step 1.
Make sure that all doors are closed and the transmission is in the
NEUTRAL position.
Engage the parking brake.
Release the brake pedal.
Press the START button for 3 seconds.
The parking lights will fl ash once and then remain on.
Remove the key from the ignition barrel : the vehicle will remain
running with the Remote-Starter.
Exit the vehicle and close all of the doors. The Remote-Starter will
stop running once all the doors are closed.
Make sure that all doors are closed and that the transmission is in
the NEUTRAL position.
While the engine is running, engage the parking brake.
Release the brake pedal.
Remove the key from the ignition barrel. The engine will shut down
and the vehicle will be ready to start at any time.
Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors
are closed.
Page 9 / 19