HP J1473A Manuel Du Propriétaire page 41

Instructions for Console Switches with Revision Code A
1. Connect the 9-pin serial cable between the Rackmount Console Switch
2. From your server, activate the OSD menu on your Rackmount Console Switch
3. Use the down arrow key to highlight the menu selection for FLASH Upgrade,
4. A menu screem will appear and ask if you wish to continue. You must type
www.hp.com/racksolutions
All manuals and user guides at all-guides.com
and the serial host system.
by tapping the Control key twice. Enter Control twice more to activate the
Administrator Commands screen and then select Administrator Functions.
then press Enter.
'Yes' before preceding. Once you have done this, the switch will go into
standby mode and wait for data from the server. (Note: The keyboard, video
and mouse are disabled during FLASH upgrade.)
Hewlett Packard Console Switch
Administrator Command Menu
Add Port
Edit Port
Delete Port
Administrative Functions
Scanning is OFF
Reset Standard Mse/Kbd
Reset Wheel Mse/Kbd
Version Information
ENTER = activate ESC = exit
Hewlett Packard Console Switch
Administrator Functions
Setup Administrator
Setup USER1
Setup USER2
Setup USER3
Setup USER4
Flash Upgrade
ENTER = activate ESC = exit
Hewlett Packard Console Switch
Flash Upgrade Confirmation
Type YES and press ENTER to
perform a Flash Upgrade
= = = WARNING = = =
During this process the
keyboard, video and mouse are
disabled until either the Flash
Upgrade is done or 3 minutes
time elapses
yes
Appendices
35