Parkside Performance PPHSA 40-Li A1 Traduction Des Instructions D'origine page 26

GB IE
your hair, clothing and gloves
away from moving parts. Loose
clothes, jewellery or long hair can be
caught­in­moving­parts.­
g) If dust extraction and collection
devices can be installed, make
sure that these are connected
and used correctly. Use of dust
collection­can­reduce­dust-related­haz-
ards.
h) Do not allow yourself to be
lulled into a false sense of se-
curity and do not disregard the
safety rules for power tools,
even if you are familiar with the
power tool after using it many
times. Careless action can lead to
serious injuries within a fraction of a
second.
4) POWER TOOL USE AND CARE
a) Do not force the power tool. Use
the correct power tool for your
application.­The­correct­power­tool­
will do the job better and safer at the
rate for which it was designed.
b) Do not use the power tool if the
switch does not turn it on and
off.­Any­power­tool­that­cannot­be­
controlled with the switch is dangerous
and­must­be­repaired.­
c) Remove the plug from the wall
socket and/or remove the re-
chargeable battery before you
change the device's settings,
change accessory parts or put
away the power tool.­Such­pre-
ventive safety measures reduce the risk
of­starting­the­power­tool­accidentaIly.­
d) Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
26
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
e) Look after the power tool and
application tool carefully. Check
for misalignment or binding
of moving parts, breakage of
parts and any other condition
that may affect the power tool's
operation. If damaged, have the
power tool repaired before use.
Many­accidents­are­caused­by­poorly­
maintained­power­tools.­
f) Keep cutting tools sharp and
clean. Properly­maintained­cutting­
tools­with­sharp­cutting­edges­are­less­
Iikely­to­bind­and­are­easier­to­control.­
g) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working condi-
tions and the work to be per-
formed.­Use­of­the­power­tool­for­op-
erations different from those intended
could result in a hazardous situation.
h) Keep handles and grip surfaces
dry, clean and free from oil and
grease. Slippery­handles­and­grip­
surfaces­do­not­permit­safe­operation­
and­control­over­the­power­tool­in­un-
expected­situations.
5) CAREFUL HANDLING AND USE
OF BATTERY DEVICES
a) Charge the batteries only in
chargers that are recommended
by the manufacturer. Risk­of­fire­if­
a­charger­that­is­suitable­for­a­specific­
type­of­battery­is­used­with­other­bat-
teries.
b) In the power tools, use only the
batteries designed for the pur-
pose. The use of other batteries may