Dimplex 6908760100 Mode D'emploi page 13

Operation
To operate, push the On button
to turn fireplace on, push the Off
button to turn the fireplace off.
!
NOTE: Before attempting
any operation with the
remote control, pull the
plastic insulator strip out from
between the remote casing
and battery cover (Figure 10).
Remote Control Initialization/
Reprogramming
In the event that your remote
control ceases to operate your
fireplace, follow these steps to
re-initialize the remote control and
the remote control receiver in the
fireplace:
1. Place the 3-Position Switch
(Figure 9A) in the Off ("O")
position.
2. Wait a minimum of five (5)
seconds and then place
the 3-Position Switch in the
Remote Control ("II") position.
3. Within 10 seconds of
changing the switch position,
press the On button located
on the remote control (Figure
10).
This will synchronize the remote
control and the remote control
receiver.
Figure 10
On
Button
Off Button
Plastic
Strip
Battery
Cover
!
NOTE: You will have only 10
seconds to perform this last step.
Failure to do so will result in these
steps needing to be followed
again.
Battery Replacement
To replace the battery:
1. Slide battery cover open on
the remote control (Figure
10).
2. Install one (1) 12-Volt (A23)
battery in the battery holder.
3. Close the battery cover
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.
13