Würth SWS 12-125-T SOLID Traduction Des Instructions De Service D'origine page 23

Working instructions
Grinding
▸
Apply moderate pressure with the machine and
move back and forth across the surface so that the
workpiece surface does not become too hot.
Roughing
▸
A good working result is obtained with a working
angle of 30° - 40°.
Cut-off grinding
Attention !
Always work up-milling mode during cut-off
¾
grinding!
Otherwise there is a risk of the machine jumping
Â
uncontrolled out of the cut.
▸
Work with moderate feed adapted to the material
being cut. Do not tilt, press or oscillate.
Sanding
▸
Apply moderate pressure with the machine and
move back and forth across the surface so that the
workpiece surface does not become too hot.
Working with wire brushes
▸
Apply moderate pressure with the machine.
Maintenance and cleaning
WARNING !
Danger of electric current.
Carry out maintenance and cleaning
¾
work on the device only when the
mains plug has been removed.
Dusts from materials can be harmful to
health.
Use a dust mask or respirator.
¾
Motor cleaning
▸
Blow out the machine with compressed air through
the rear ventilation slots regularly, frequently and
thoroughly. Hold the machine firmly while blowing
out.
Risk of injuries or property damage due
to improper actions.
Do not open the device.
¾
The device must only be opened by a
¾
Würth service technician.
Observe the relevant safety and
¾
accident prevention regulations
during all maintenance and servicing
work.
Troubleshooting
Machine not running. Electronic signal dis-
play (depending on configuration) flashes:
The restart protection device has tripped. If the mains
plug is inserted with the machine switched on, or if
the power supply is restored after an interruption, the
machine does not start.
▸
Switch the machine off and on again.
CAUTION !
CAUTION !
23