Würth SWS 12-125-T SOLID Traduction Des Instructions De Service D'origine page 22

Fitting abrasive wheel or disc
▸
The autobalancer support flange [7] is fixed to
the spindle.
A removable support flange, as on the other angle
3
grinders, is not required.
▸
Push the abrasive wheel [11] onto the auto-
balancer support flange [7].
• The grinding wheel must rest uniformly on the
supporting flange.
• The sheet metal flange of cut-off wheels must rest
on the supporting flange.
Risk of severe injuries
For safety reasons, always use the
¾
cut-off safety hood when working
with cutting wheels.
Quick-clamping nut (depending on
configuration)
Tightening the quick-clamping nut
Attention !
Only attach the quick-clamping nut [12] to
machines with the "quick-clamping system".
▸
Lock the spindle.
▸
Push the quick-clamping nut [12] onto the
spindle [6] so that the two lugs engage in the two
grooves of the spindle.
▸
Tightening the quick-clamping nut in clockwise
direction by hand.
▸
Tighten the quick-clamping nut further by turning
the abrasive wheel firmly in a clockwise direction.
Loosening the quick-clamping nut
Attention !
Only when the quick-clamping nut [12] is
¾
attached may the spindle be stopped using the
red spindle locking knob [8]!
▸
The machine runs on after switching off. Just
before the abrasive wheel comes to a standstill,
press the red spindle locking knob [8].
The quick-clamping nut [12] is loosened auto-
3
matically by approx. half a turn and can then be
unscrewed without additional force or tools.
22
CAUTION !
Operation
Switching ON/OFF
WARNING !
Risk of severe injuries.
Always guide the machine with both
¾
hands.
First switch on, then bring the
¾
attachment into contact with the
workpiece.
WARNING !
Danger of unintentional starting
Always switch off the machine when
¾
the mains plug is removed from the
plug socket or if a power failure has
occurred.
Risk of a dust explosion.
Take care to prevent the machine
¾
from drawing in additional dust and
chips.
Keep away from dust deposits when
¾
switching the machine ON and OFF.
Switch ON
▸
Push the switch-on inhibitor [2] in the direction of
the arrow and press the trigger switch [1].
Switch OFF
▸
Release the trigger switch [1].
DANGER !