Using The Feed Chute And Pushers - Black & Decker Performance FP6000 Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Attach your selected blade or disk to the center post
in the bottom of the large workbowl (instructions for
individual disks/blades follow in this manual).
5. Place the workbowl lid on top of the workbowl,
aligning the tabs and locking it into place by turning
counterclockwise. The workbowl lid is locked when
it clicks firmly into place. The lid will always and
only lock when the feed chute is aligned with the
workbowl handle. (B)
Note: Be sure to lock the workbowl in place before
attaching the blades or disks and lid.
6. Insert the large food pusher into the feed chute of
the lid. Push down until the pusher clicks into place
and rests at the bottom of the feed chute. (C)
7. Plug in the appliance. If the appliance is properly
assembled, the light will illuminate. If it does not, the
interlocks are not properly engaged.
Important: For your protection this appliance has an interlock system. The
processor will not operate unless the lid and large pusher are properly locked
in place. The light will illuminate when the base, lid and large pusher are in the
proper position.
US IN G T H E F E E D C HUTE AN D PUSHERS
Note: Before operating the food processor, be sure
the workbowl, blades and workbowl lid are properly
assembled on the food processor base.
1. Insert the large food pusher into the wide mouth
feed chute. Insert the medium pusher inside the
large pusher and the small food pusher inside the
medium pusher. The food pushers are used to guide
ingredients through the feed chute. The small and
medium food pushers can be removed to add liquid
or additional foods. (D)
Note: The large pusher must remain in the feed chute in order for the processor
to operate. The unit will continue to operate if the medium or small pushers are
removed from the large pusher.
2. Place food to be processed in the opening of the large pusher. Use the
medium pusher to guide food through the large pusher and feed chute.
3. Use the small food pusher to guide smaller diameter foods through the
medium pusher.
4. Use the small food pusher as a measuring cup to add liquids during
processing.
7
B
C
D

Publicité

Table des Matières
loading

Table des Matières