Roco BR 95 Manuel page 41

Please note! To achieve proper mounting of the enclosed etched labels will you please follow these instructions:
As delivered the etched label surface is completely covered with paint. To make the metal numbers and letters visible the paint must be remo-
ved from the actual letter and numeral surfaces: this is done as follows:
1. Remove printed labels from the frame!
2. Dont remove the remaining signs from frame. Place them with their backs on a firm and completely level surface
3. Remove the paint from the surface of the characters carefully either with the ROCO rubber (art. no. 10002) a sharp knife having a straight
edge or similar
object (e.g. single-edge razor blade). Take care that while doing this the paint surface between the characters is not damaged.
4. If the result is not satisfactory it is recommended that the remaining paint is removed with a suitable paint remover. Thoroughly dry the
labels and then
reapply fresh paint. Repeat the removal of the paint from the surface of the characters after the new paint is completely dry.
5. Carefully extract the different labels from their etching frames and remove any remaining burrs.
6. Attach the etched labels with very small amounts of adhesive on top of the printed signs on the vehicle.
71095.indd 41 71095.indd 41
Working with etched Labels
41
14.09.2021 10:40:57 14.09.2021 10:40:57