Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a service tech-
nician.
If something is wrong with this product, check the following before calling your autho-
rised SHARP dealer or service centre.
„ General
Symptom
z The clock is not on time.
z Did a power failure occur? Reset the
clock. (Refer to page 10.)
z When a button is pressed, the unit
z Set this unit to the power stand-by mode
does not respond.
and then turn it back on.
z If the unit still malfunctions, reset it. (Refer
to page 27.)
z No sound is heard.
z Is the volume level set to "0"?
z Are the headphones connected?
z Are the speaker wires disconnected?
„ CD player
Symptom
z Playback does not start.
z Is the disc loaded upside down?
z Playback stops in the middle or is
z Does the disc satisfy the standards?
not performed properly.
z Is the disc distorted or scratched?
z Playback sounds are skipped, or
z Is the unit located near excessive vibra-
stopped in the middle of a track.
tions?
z Is the disc very dirty?
z Has condensation formed inside the unit?
„ Tuner
Symptom
z Radio makes unusual noise con-
z Is the unit placed near the TV or comput-
secutively.
er?
z Is the FM aerial or AM loop aerial placed
properly? Move the AC power lead or the
unit away from the aerial if located near.
„ Cassette deck
z Cannot record.
z Cannot record tracks with proper
sound quality.
Possible cause
z Cannot erase completely.
z Sound skipping.
z Cannot hear treble.
z Sound fluctuation.
z Cannot remove the tape.
„ Remote control
Possible cause
z The remote control does not oper-
ate.
„ Condensation
Sudden temperature changes, storage or opera-
tion in an extremely humid environment may
Possible cause
cause condensation inside the cabinet (CD pick-
up, tape heads, etc.) or on the transmitter on the
remote control.
Condensation can cause the unit to malfunction.
If this happens, leave the power on with no disc
(or cassette) in the unit until normal playback is
possible (about 1 hour). Wipe off any condensa-
tion on the transmitter with a soft cloth before op-
erating the unit.
Symptom
Possible cause
z Is the erase-prevention tab removed?
z Is it a normal tape? (You cannot record on
a metal or CrO tape.)
z Is there any slack?
z Is the tape stretched?
z Are the capstans, pinch rollers, or heads
dirty?
z If a power failure occurs during playback,
the heads remain engaged with the tape.
Do not open the compartment forcibly.
Wait until electricity resumes.
Symptom
Possible cause
z Is the AC power lead of the unit plugged
in?
z Is the battery polarity respected?
z Are the batteries dead?
z Is the distance or angle incorrect?
z Does the remote control sensor receive
strong light?
01/12/11
CD-XP300H(H)E3.fm
CD-XP300H
ENGLISH
E-26
Publicité
