Installation; Mount To 5 In./6 In. Housing With Ears; Mount To 5 In./6 In. Housing Without Ears - ETI 53186142 Manuel

Mount to 5 in./6 in. Housing with ears (continued)
5
inserting the spring clips into
the recessed can
□ Compress the spring clips on the LED light module (A)
and insert into the ears on the inside of the recessed can
housing.
Spring Clips
A
Mount to 5 in./6 in. Housing without ears - item # 53186142
1
Turning off the power
□ Make sure the power is turned off at the source to
the recessed can housing where the fixture will be
installed. Remove the existing bulb and trim, revealing
the socket.
nOTiCe: Stick the replacement label on
the inner wall of the recessed housing before

installation.

6
Pushing the LED light module into
the recessed can
□ Carefully push the LED light module (A) into the recessed
can housing until the trim is flush with the ceiling surface.
nOTiCe: Select the preferred color temperature
of the light before pushing the LED light module
into the recessed can housing.
A
2
Replacing the spring clips with
friction clips
□ Unscrew the two brackets holding the spring clips
and remove them. install two friction clips (C)
onto the LED light module (A) using the screws
removed from the spring clip brackets. For a 5 in.
recessed can housing, tighten the screws into the
holes labeled "5" using a Phillips screwdriver (not
included). For a 6 in. can, tighten the screws into the
holes just to the right of "6". For cans up to 6.7 in.,
choose a hole to the left of "6" for best fit.
For 5 in. cans For 6 in. cans For 6+ in. cans
C
A
C
A
6
Mount to 5 in./6 in. Housing without ears (continued)
3
Connecting the socket adapter
□ Screw the medium base (E26) socket adapter (B)
into the socket in the recessed housing.
B
5
inserting the friction clips into
the recessed can
□ insert one side of the downlight into the recessed
can and firmly push against the friction clip (C), while
inserting the other side into the can housing.
A
C
4
Connecting the cables
□ Plug the cable connector on the socket adapter (B)
into the connector on the LED light module (A).
B
6
Pushing the LED light module into
the recessed can
□ Once both clips are inside, carefully push the LED light
module (A) up into the recessed can housing until the
trim is flush with the ceiling surface.
nOTiCe: Select the preferred color temperature
of the light before pushing the LED light module
into the recessed can housing.
C
7
Please contact 1-855-384-7754 for further assistance.
A
A
WWW.ETiSSL.COM