Nice AVIO500 Instructions Et Avertissements Pour L'installation Et L'utilisation page 53

STEP 16
This user guide should be stored and handed to all users
of the automation.
16.1 – WARNINGS
• Keep at a safe distance from the moving door until it is
completely open or closed; do not transit through the
door until it is completely open and has come to a stand-
still.
• Do not let children play near the door or with its com-
mands.
• Keep the transmitters away from children.
• Suspend the use of the automation immediately as soon
as you notice something abnormal in the operation (nois-
es or jolting movements); failure to follow this warning
may cause serious danger and accidents.
• Do not touch moving parts.
• Regular maintenance checks must be carried out by
qualified personnel according to the maintenance plan.
• Maintenance or repairs must only be carried out by quali-
fied technical personnel.
• Send a command with the safety devices disabled:
If the safety devices do not work properly or are out of order, the
door can still be operated.
01. Command the door with the transmitter. If the safety devices
give the enable signal, the door opens normally; otherwise, reat-
tempt within 3 seconds and keep the control activated. 02. After
approximately 2 seconds the door will start moving in the "man
present" mode, that is, so long as the control is kept activated
the door will keep moving; as soon as the control is released the
door will stop.
If the safety devices are out of order, arrange to repair the auto-
mation as soon as possible.
16.2 – Manually releasing and locking
The gearmotor is equipped with a mechanical system that allows
for opening and closing the door manually.
Manual operation must be performed in the case of a power out-
age or in the event of anomalies affecting the system.
1 Pull the release cord down until
you hear the carriage being relea-
sed.
2 The door can now be moved
manually.
The activation of the manual
release may cause an uncon-
trollable movement of the door
if the springs are weak or bro-
ken, or if the door is off-balance.
To restore the functionality of the automation system, move the
door back in position until you hear the carriage being enga-
ged.
In the event of a gearmotor fault, it is still possible to try release
the motor to check whether the fault lies in the release mecha-
nism.
16.3 – User-admissible maintenance operations
The operations that the user must carry out periodically are listed
below:
• Cleaning of the surfaces of the devices: use a slightly
USER MANUAL (to be delivered to the end user)
the gearmotor
damp (not wet) cloth. Do not use substances containing
alcohol, benzene, thinners or other flammable substanc-
es; the use of these substances may damage the devices
and cause fires or electric shocks.
• Removal of leaves and stones: disconnect the power
supply before proceeding, so as to prevent anyone from
moving the door.
16.4 – Replacing the transmitter battery
When the battery is flat, the transmitter capacity is significantly
reduced. If, when a button is pressed, the relevant Led turns on
then immediately fades and turns off, it means that the battery is
completely flat and should be immediately replaced.
If instead the Led turns on only for a moment, it means that the
battery is partially flat; the button must be kept pressed for at
least half a second for the transmitter to attempt to send the
command.
However, if the battery level is too low to complete the command
(and possibly wait for the response), the transmitter will turn off
and the relevant Led will fade. In these cases, normal transmitter
operation can be restored by replacing the battery with another
of the same type, while observing the relevant polarity. To replace
the battery, proceed as shown below.
a
c
Batteries contain polluting substances: do not dispose
of them together with common waste but use the methods
set forth in the local regulations.
b
d
English – 27