Adding Or Removing Roof Panel; Adding Or Removing Side Panels - Tripp-Lite SmartRack AG-039A Manuel Du Propriétaire

Enclosure Configuration

Adding or Removing Roof Panel

WARNING: Do not attempt to use the roof panel for weight-bearing purposes other than those explicitly described and approved by Tripp Lite.
Do not attempt to add or remove the roof panel without assistance.
Removing Roof Panel
1 Pull the 2 pins near the rear of the roof panel. While holding the pins, push the roof panel upward.
2 Remove the roof panel tabs
3 Lift the roof panel from the enclosure.
To Reinstall Roof Panel, Reverse Steps 1-3

Adding or Removing Side Panels

Removing Side Panel
1 Open the latch by sliding it downward.
2 Tilt the top of the panel away from the enclosure.
A from the roof panel attachment slots B in the enclosure frame.
9
2
1
A
B
2
3
1
2
1