Basic Operation; Front Panel Switches - Tripp-Lite SmartOnline SU750RTXL2U Manuel Du Propriétaire

Basic Operation

Front Panel Switches

Front Panel Indicator Lights
17-05-032-932471.indb 9
"ON/TEST" Button: This switch controls four separate UPS functions:
UPS Power ON
To turn the UPS on, press this button, hold for several seconds until you
hear a beep, then release. The "ON LINE" LED will illuminate.
UPS Self-Test
During normal on-line operation, press this button and hold it until you
hear a beep. This initiates a 10-second battery self-test. The UPS will
shift to battery power (all LEDs will illuminate) for ten seconds.
Alarm Silence
To silence the UPS "on-battery" alarm, press this button and hold it until
you hear a beep.
UPS Cold Start
To use your UPS as a standalone power source when AC power is
unavailable (i.e. during a blackout), press this button and hold it until you
hear a beep. The UPS will then provide battery power to its outlets.*
* The "ON BATT" Indicator Light will be illuminated since your UPS will be operating
from battery power.
"OFF" Button: This button turns power OFF at the UPS receptacles.
Press this switch, hold until you hear a beep, then release. The UPS will
continue charging and the fan will continue to cool internal components
even after you turn the UPS receptacles off. To turn the UPS OFF
completely, including the charger, disconnect the UPS's power cord after
pressing the "OFF" switch.
"ON LINE" LED: This green light will illuminate constantly to indicate the
UPS is performing normal on-line operation (filtering and resynthesizing
incoming AC line voltage to provide pure sine wave output). When this
light is illuminated, you can monitor the load level of your UPS on the
"LOAD ACTIVE METER" LEDs.
"LINE" LED: This green light will illuminate constantly to indicate the
utility supplied AC line voltage at your wall outlet is nominal. It will flash if
the line voltage is outside the nominal range (either too low or two high).
No action is required on your part when the LED flashes; the UPS
continuously and automatically filters AC line power to provide your
equipment with pure sine wave AC power, regardless of brownout or
overvoltage conditions. If this light is off, then AC line voltage is not
present (blackout) or is at an extremely high voltage, and the UPS will
provide connected equipment with power from battery.
9
5/23/2017 1:41:45 PM