Optional Connections - Tripp-Lite SmartOnline SU750RTXL2U Manuel Du Propriétaire

Installation
3
Turn your UPS ON:
• Press the "ON/TEST" Button
• Hold it for several seconds until you
hear a beep
• Release it
Your UPS will begin providing AC power to
its outlets. The "ON LINE" LED will
illuminate.
Note: UPS system will function properly upon
initial startup; however, maximum runtime for
the unit's battery will only be accessible after it
has been charged for 24 hours.

Optional Connections

Your UPS will function properly without these connections.
1
Phone Line or Phone/Network
Line Surge Suppression
Your UPS has jacks which protect against
surges on a phone line. Select models
feature jacks which also protect against
surges on a network line.* Using
appropriate telephone or network cords
connect your wall jack to the UPS jack
marked "IN." Connect your equipment to
the UPS jack marked "OUT." Make sure
the equipment you connect to the UPS
jacks is also protected against surges on
the AC line.
* Not compatible with PoE (Power Over Ethernet)
applications.
2
USB and RS-232 Serial
Communications
Use the included USB cable
DB9 serial cable
communication port of your computer to
the communication port of your UPS.
Install on your computer the Tripp Lite
PowerAlert ® Software appropriate to your
computer's operating system. Your UPS
may feature additional communications
ports; these ports may be connected to
additional computers that have PowerAlert
Software installed. Consult your PowerAlert
manual for more information.
17-05-032-932471.indb 6
2a
and/or
2b
to connect the
3
1
Your model may differ.
Your model
2a
may differ.
2b Your model may differ.
6
5/23/2017 1:41:44 PM