Connection And Start-Up - Tripp-Lite SmartOnline SU750RTXL2U Manuel Du Propriétaire

Installation
2-Post (Telecom) Mounting
If you mount 2U UPS models in 2-post racks, they require the addition of a Tripp Lite 2-Post
Rackmount Installation Kit (model: 2POSTKITRMWM, sold separately). See Installation Kit
owner's manual for installation procedure for 2U UPS models.
Mounting (Tower)
Your UPS can be mounted in an upright tower
position with optional base stands sold
separately by Tripp Lite (Model #
2-9USTAND). When mounting the UPS on
adjustable base stands, make sure that the
control panel is toward the top. The control
panel may be rotated to make it easier to
read. Insert a small screwdriver or similar tool
in the slots on either side of the panel, pop it
out, rotate it, and pop it back into place as
shown.
WARNING!
All UPS systems are extremely
heavy. Use caution when lifting
and mounting. User must properly
stabilize the UPS when lifting and
mounting.

Connection and Start-Up

1
Plug your UPS line cord into an
electrical outlet.
Your UPS must be connected to a
dedicated circuit of sufficient amperage.
However, the select models may be fitted
with different plug types. Refer to the "OP
Rating/Plug Rating" chart printed on the
top of your UPS.
Once your UPS is plugged in, the fan and
all Indicator Lights will turn ON. The "LINE"
and "LOAD ACTIVE METER" LEDs will
illuminate and the UPS will beep to
indicate normal operation. However, power
is not supplied to your UPS AC outlets
until the UPS is turned on.
2
Plug your equipment into your UPS.
Your UPS is designed to support computer
equipment only. You will overload your
UPS if you connect household appliances
or laser printers to the UPS outlets.
17-05-032-932471.indb 5
1
Your model may differ.
2
Your model may differ.
5
5/23/2017 1:41:43 PM