IKEA SMAKLIG Mode D'emploi page 14

ENGLISH
What to do if...
Problem
The appliance cannot be
switched on or is not operat-
ing.
Acoustic signal sounds, ap-
pliance switches off.
Display is switching between
two heat settings.
The residual heat indicator is
not displaying anything.
There is no signal when you
touch the panel sensor fields.
lights up on the heat set-
ting display.
Possible cause
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
More than 10 seconds
passed since you switched
on the hob.
The Child Safety Device or
the Lock is on .
Several sensor fields were
touched at the same time.
One or more sensor fields
have been covered for lon-
ger than 10 seconds.
Power management is re-
ducing the power of this
cooking zone.
The cooking zone was only
on for a short time and is
therefore not hot.
The signals are deactivated. Activate the signals. Refer to
Unsuitable cookware.
No cookware on the cooking
zone.
The diameter of the bottom
of the cookware is too small
for the cooking zone.
Remedy
Check if the appliance is cor-
rectly connected to the elec-
trical supply (refer to con-
nection diagram).
Switch the appliance on
again.
Deactivate the Child Safety
Device (See the section
"Child Safety Device" or
"Lock").
Only touch one sensor field.
Uncover sensor field.
See the section "Power man-
agement".
If the cooking zone is sup-
posed to be hot, call an Af-
ter Sales Service.
OffSound Control.
Use suitable cookware.
Place cookware on the cook-
ing zone.
Move onto a smaller cooking
zone.
14