The Cone; The Base - OFYR CLASSIC Mode D'emploi

•
If you use your OFYR
on the cooking plate, making it extra smooth and extra comfortable to use. From time to
time, this layer might come off here and there. When you spot it chipping in places,
simply scrape off the chips using the spatula, and rub on new oil. The carbon residue
layer will gradually renew itself this way.

6.2 THE CONE

•
To prevent the cone from getting clogged, the ashes need to be removed after every use.
•
If wed ash is left for a too long period in the cone or if the OFYR Cooking Unit is in a very
wet or salty region, steel chips may form on both the inside and outside of the Corten steel
cones. These chips can easily be removed with the spatula. The video "Maintenance of the
OFYR Corten Cone" clearly shows how to proceed.

6.3 THE BASE

•
While cooking oil splashes may form on the base. From the Corten steel bases these
splashes cannot be removed. However, the entire Corten steel base can be treated
with oil using a kitchen towel making the splashes invisible. Such treatment will make
the entire base darker. When it rains, slightly greasy water may run off the Corten base,
which may permanently stain light-toned stone or wooden surfaces.
•
The Concrete base has been treated with wax in order to make the surface shiny.
Due to weather and sunlight this shiny appearance will disappear over time.
Therefore the Concrete comes with additional wax to make the base shiny again.
10 12
Cooking Unit a lot, a smooth layer of carbon residue will build up
®
OFYR OFYR MANUAL - OFYR MANUAL - COOKING UNITS - CLASSIC COOKING UNITS - CLASSIC
® ® ®