Jonsered LM 2146CMD Manuel D'utilisation page 69

• Make sure the cutter centers correctly on the shaft.
• Fit the washer and tighten the bolt correctly. The bolt
should be tightened with a torque of 45-60 Nm.
• Pull the blade around by hand and make sure it
rotates freely.
• Test run the machine.
IMPORTANT!
Always exercise care and use your common sense.
Avoid all situations which you consider to be beyond your
capability. If you still feel uncertain about operating
procedures after reading these instructions, you should
consult an expert before continuing. Contact an
authorised service workshop.
Always use genuine parts. For more information, see the
"Technical data" section.
Spark plug
NOTICE! Always use the recommended spark plug type!
Use of the wrong spark plug can damage the piston/
cylinder.
• If the machine is low on power, difficult to start or runs
poorly at idle speed: always check the spark plug first
before taking other steps.
• If the spark plug is dirty, clean it and check that the
electrode gap is 0.5 mm. Replace if necessary.
MAINTENANCE
Adjusting the clutch wire
Roughly adjust the cluch wire by attaching it to the
different brackets on the clutch bar. Then adjust the wire
finely.
Air filter
• Remove the air filter cover and take out the filter.
• An air filter that has been in use for a long time cannot
be cleaned completely. The filter must therefore be
replaced with a new one at regular intervals. A
damaged air filter must always be replaced.
• When reassembling, make sure that the filter
completely seals against the filter holder.
Clean the paper filter
• Clean the filter by knocking the filter against a flat
surface. Never use solvent with petroleum, for
example, kerosene, or compressed air to clean the
filter.
Cleaning the foam plastic filter
• Remove the foam plastic filter. Wash the filter well in
tepid soapy water. After cleaning, rinse the filter well in
clean water. Squeeze out and allow the filter to dry.
NOTE! High pressure compressed air can damage
the foam. After cleaning the filter should be oiled using
engine oil. Wipe away excess oil by pressing a clean
cloth against the filter.
Oil change
• Empty the fuel tank.
• Unscrew the oil filler cap.
• Place a suitable vessel to collect the oil in.
• Drain the oil by tipping the engine so that the oil runs
out through the filler pipe. When the machine is tilted,
make sure the air filter always is placed in the highest
position. Ask where you can dispose of surplus
engine oil at your local petrol station.
• Fill with new engine oil of a good quality. See
instructions in the section "Technical data".
Fuel system
• Check that the fuel cap and its seal are not damaged.
• Check the fuel hose. Replace if necessary.
–
English 69