Publicité
Les langues disponibles
Les langues disponibles
01-01RBC-AMS41E_EN.fm Page 5 Friday, April 18, 2008 9:53 AM
Setting the current day of the week and clock time
• Set the current clock time and day of the week.
• The day of the week and clock settings can be
performed whether the air conditioner is running or
shut down.
* The air conditioner continues to operate (run) while
the day of the week and clock settings are being
performed.
• The normal operation of the air conditioner or a
program for a scheduled operation can be input even
without performing the day of the week and clock
settings, but the scheduled operation cannot be
executed. In order to execute scheduled operations,
the day of the week and clock must be set without fail.
• Before this remote controller is shipped from the
factory, the initial setting (default) of the 24-hour
display is established for the clock time display, but
this can be changed to the 12-hour (AM/PM) display.
* If you want to use the 12-hour time display, refer to
the "Selecting the remote controller functions"
section.
* In these instructions, the 24-hour display is used in
the figure and descriptions.
Preparations
Turn on the ground fault interrupter.
• When the power is turned on, a dividing line appears
on the remote controller display.
* For about a minute after the power has been turned
on,
on the LCD screen blinks, and there
will be no response to the keys of the remote
controller even when they are pushed.
1
Hold down the
for at least 4 seconds.
• The display transfers to the day
of the week/clock setting screen.
• The whole LCD display blinks.
2
Repeatedly push the
(45), and select the current day of the week.
• Move the day arrow
current day of the week.
• The LCD display continues to blink.
3
Push the TIME
select the current clock time.
• Each time the
is moved forward by one minute.
• Each time the
is moved back by one minute.
• When the
or
is moved forward or back in 10-minute increments.
• The LCD display continues to blink.
button (48)
<Blinks>
button
to the position above the
and
buttons (40), and
button (40) is pushed, the clock
button (40) is pushed, the clock
button is held down, the clock
4
Push the
button (42) to return to the original
screen.
• As soon as the button is pushed, the clock starts
running. (Do this in synchronization with a time
signal.)
•
on the LCD screen goes off.
• After the clock has been set, the entire LCD screen
lights, but the colon (" ") continues to blink.
EN
5
Publicité
