Publicité
Les langues disponibles
Les langues disponibles
01-01RBC-AMS41E_EN.fm Page 17 Friday, April 18, 2008 9:53 AM
Timer operations
• Before this remote controller is shipped from the
factory, the schedule timer operation function is set as
an initial setting (default), but the count-down timer
operation function can be selected instead.
* Users who want the timer operation function should
refer to the "Selecting the remote controller
functions" section.
* Bear in mind that if the timer operation function has
been selected, the scheduled operation function
cannot be used.
• The three following functions can be selected by the
timer operation function:
OFF timer:
Operation is shut down when the set time is reached.
Repeated OFF timer:
Every time operation is started, it is shut down after
the set duration.
ON timer:
Operation is started when the set time is reached.
* The maximum time which can be set is 168 hours (7
days).
Timer operations
How to execute timer operations
1
During operation, push the
select the timer operation which is to be set.
• The
display and numeric display blink,
and the timer function display lights.
• Each time the button is pushed, what appears on
the timer function display changes in the following
sequence.
• Stop pushing the button when the desired
operation lights up on the display.
OFF timer
2
Push the TIME
select the set time.
• Each time the
time is moved forward in half-hour (30-minute)
increments. If the set time is more than one day (24
hours) ahead, it is moved forward in 1-hour
increments. The upper limit is 7 days (168 hours)
ahead.
The numbers representing any set time from 0.5
hour to 23.5 hours appear on the numeric display.
For a set time more than 24 hours ahead, the
number of days and time are indicated.
• Each time the
time is moved back in half-hour (30-minute)
increments (from 0.5 hour to 23.5 hours) or in 1-
hour increments (from 24 hours to 168 hours).
button (48), and
No timer
(No display)
Repeated
ON timer
OFF timer
and
buttons (40), and
button (40) is pushed, the set
button (40) is pushed, the set
Example of remote controller display
• When the set time is 23.5 hours ahead
• When the set time is 34 hours ahead
"1d" = 1 day = 24 hours
"10H" = 10 hours
Total = 34 hours
3
Push the
button (42).
• The numeric display stops blinking and lights up,
and the timer function display changes to blinking
from its lighted status.
• The
display goes off.
* When the ON timer function is set, the operation
of the air conditioner is shut down. This means
that apart from the lighted numeric display and
blinking timer function display, all other displays
go off.
How to cancel a timer operation
1
Push the
button (41) during the timer
operation.
• The timer function display and numeric display go
off.
* A timer operation can be canceled while the timer
operation is being set or executed.
EN
17
Publicité
