Ugolini NG6 Easy Carnet D'instructions page 21

2 Pour about eight litres of a solution made of hot water (45-
60 °C) and sodium hypochlorite (bleach) at a ratio of 1
tablespoon per 2 litres of water.
3 Immerse all parts to be sanitised in the solution for the time
indicated by the product manufacturer.
4 Allow the sanitised parts to air dry on a clean surface.
5 Dry the external parts of the dispenser without using
abrasive cloths.
9. 5 REFITTING THE RECOVER (OPTIONAL)
1 Click open the two parts. (see figure 16).
figure 16
2 Remove the left-hand part and then the right-hand part of
the recover. (see figure 17)(see figure 18).
figure 17
figure 18
9. 6 ASSEMBLY
1 Slide the drip tray into place..
2 Lubricate the tap piston, the hexagonal joint and the mixer
at the points indicated in figure 19 (NG6) or figure 20 (NG10),
using only the grease that came with the machine or other
grease for use with food.
3 Reassemble the tap on the container in reverse order
compared to that shown in figure 14.
4 Replace the container gasket.
N.B. the rim with the greater diameter must be rested on the
rear wall (see figure 21).
5 Reassemble the hexagonal joint and then the mixer (see
21
figure 19
figure 20
figure 21