Ugolini NG6 Easy Carnet D'instructions page 20

cylinder. Then remove the hexagonal joint (see figure 12).
figure 12
4 Remove the gasket from its housing (see figure 13).
figure 13
5 Disassemble the tap by following the order given (see figure
14).
figure 14
6 Remove the drip tray and empty it.
7 Remove the flow restrictor from the container (see figure
15).
9. 3 WASHING
IMPORTANT
Do not wash any part of the machine in a dishwasher.
ATTENTION
Before any cleaning operation, always unplug the
dispenser from the mains or turn off the external wall
switch.
1 Fill a basin with approximately one gallon of hot water (45-
60°C) and sodium hypochlorite (bleach) at a ratio of 1
tablespoon per 2 litres of water; indeed, a solution that is too
concentrated may damage the parts to be washed, whereas
one that is too diluted may not clean properly. Do not use any
abrasive detergents.
IMPORTANT
In order to prevent damage to the dispenser, use only
detergents that are compatible with the plastic parts.
2 In order to avoid damaging the dispenser, only use
detergents that are compatible with plastic components.
ATTENTION
While washing the dispenser, do not use excessive
amounts of water around the electrical components. This
could cause electric shocks or damage to the dispenser.
3 Wash the evaporator cylinder, the upper tank and the
connecting pipe using the brush supplied with the unit.
4 Rinse all washed parts under running water.
9. 4 SANITISING
Sanitising must be done immediately before starting up the
dispenser. Do not allow it to remain idle for a long time after
sanitisation.
Sanitization must be performed whenever the distributor is
put back into operation with a new product.
1 Before starting the procedures described below, wash your
hands with antibacterial soap.
20
figure 15