Exemption From Liability; Intended Use; Features - Olympia A 390 Mode D'emploi

Exemption From Liability

We cannot guarantee that the information on the technical properties and
that contained in this document is correct. The product and, where applica-
ble, its accessories, described in this document are subject to constant im-
provement and further development. For this reason, we reserve the right to
modify components, accessories, technical specifications and related docu-
mentation of the product at any time without notification.

Intended Use

This laminator has been conceived for use processing hot and cold laminat-
ing foil. It is possible to laminate pictures, maps, documents, paper etc. up to
a total thickness of 0.5 mm. Any other use is considered unintended use.
Unauthorised modifications or reconstructions are not permitted.
Safety note:
The power socket must be located close to the equipment and be easily ac-
cessible. This enables the equipment to be disconnected from the power
supply quickly in an emergency.

Features

Protection and refinement of your documents.
Laminate photographs, documents, graphics, identity cards etc. up to A4
size. The unit operates using 2 heating rollers, has a quick warm-up phase
and laminates without a carrier.

2 LED lamps indicate the operating states "Cold laminating ready"
and "Hot laminating ready"

Automatic switch-off in the event of overheating

High quality heating system prevents smudging and blistering

Warm-up phase only about 4 minutes

Cool down phase to room temperature, approx. 30 minutes
 Foil thickness, minimum 75 m and maximum 150 m
Laminating system:
Working width:
Laminating temperature:
Maximum laminating width:
Maximum foil thickness:
Laminating speed:
Power supply:
Power consumption:
Dimensions (LxWxH):
Hot roller technology
329 mm (A3)
97 - 105 °C, 0 – 35 °C
329 mm
75 – 150 micron
246 mm/min
220 - 240 Volt, 50 Hz
1.5 A
428.5 x 105 x 90 mm
11