Publicité
Les langues disponibles
Les langues disponibles
Failed Reception
During reception, press
Indication:-
When strong DCF signal is detected, display shows with 3 bars
When weak or no DCF signal is detected, display shows
During reception, the signal strength may move from 1 bar to 2 bars to 3 bars. This is normal since
the clock is detecting DCF signal and other signals in the air at the same time.
Press SET will return to the time display with
Successful reception or failed reception
icon becomes static on (stop blinking) when reception is successful
icon disappears when reception is failed
Automatic reception and Manual Reception
Your clock starts automatic reception everyday at 1:00, 2:00, and 3:00. If it fails to receive the DCF
time signal at 3:00, it will start reception at 4:00. If it fails again, it will start reception at 5:00. If it
fails again, it will start automatic reception at 1:00 again in the next day.
Manual reception: simply press and hold
manual reception. Press and hold
When your weather station is receiving the radio controlled time signal, the display will turn dimmer. It
will resume to the brightness level which you originally selected after the radio controlled time
reception is completed.
During RCC reception, all buttons do not function and it does not take temperature measurement.
The temperature readings will get stable and become more accurate after your weather station clock
is powered up for around 30 minutes.
To cancel DCF reception permanently
Press and hold
/ WAVE and
and the radio controlled function is permanently disabled.
To resume the radio controlled function, press and hold
seconds, your clock will give 2 short beep and will start DCF immediately.
TO SET TIME
1.
Press and hold SET, 00 flash, press
"00" = GMT +1 hour (e.g. Germany)
"01" = GMT +2 hours (e.g. Finland)
"-01" = GMT 00 hour (e.g. U.K.)
2.
Press SET again, hour digits flash. Press
or
to accelerate setting at high speed.
3.
Press SET again, the minute digits flash. Press
to accelerate setting at high speed.
(
icon disappear)
/ WAVE once will display reception mode and signal strength
/ WAVE, your clock will gives a short beep and starts
/ WAVE to stop DCF reception.
at the same time for 2 seconds, your clock will give 2 short beep
icon flashing.
/ WAVE and
/
to set the time zone: -01 or 00 or 01.
/
to set the current hour. Press and hold
/
to set minutes. Press and hold
or
at the same time for 2
or
GB 5
Publicité
