Maintenance; Mnvcwasex_2222_En; Routine Maintenance; Filling The Tank - Videotec WASEX Manuel D'instructions

7 Maintenance

Before carrying out any type of
maintenance, read the "Safety rules"
chapter carefully in the product manual.
Please provide the device serial number when
requesting any replacement parts.

7.1 Routine maintenance

7.1.1 Filling the tank

Fill the tank with reference to the pump installation
procedure (6.11 Filling the tank, page 17).

7.1.2 Inspecting the cables

The cables should not show signs of damage or
wear, which could generate hazardous situations. In
this case extraordinary maintenance is necessary.

8 Cleaning

8.1 Routine cleaning

The outside surface of the product must
never be covered in more than 5 mm of
dust.
Frequency will depend on the type of
environment in which the product is used.
The device should be cleaned using a damp cloth;
compressed air must not be used.
22
9 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE)
mandates that these devices should not be disposed
of in the normal flow of municipal solid waste, but
they should be collected separately in order to
optimize the recovery stream and recycling of the
materials that they contain and to reduce the impact
on human health and the environment due to the
presence of potentially hazardous substances.
The symbol of the crossed out bin is
marked on all products to remember this.
The waste may be delivered to appropriate
collection centers, or may be delivered free of
charge to the distributor where you purchased
the equipment at the time of purchase of a new
equivalent or without obligation to a new purchase
for equipment with size smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.

MNVCWASEX_2222_EN