Publicité
Les langues disponibles
Les langues disponibles
17
EN
Shortening the belts
The carrying straps may be shortened to the desired length if
needed. Afterwards, use a match or a lighter to melt the edges
of the cut to prevent fraying. The waist strap can be shortened
along the markings to the desired length as well. It is NOT ne-
cessary to scorch / singe the ends here!
BEFORE shortening the belts, be sure the BP1
Protect size is correctly adjusted (see page 13 —15)
and that you know the belt length you actually
need! Belts that have been overshortened cannot
be considered a reason for return of the product!
After shortening, the product cannot be replaced!
Cleaning and maintenance
Clean and dry your BP1 Protect after each use to keep it in top condition. Use only luke warm water and a soft sponge. Do not
use hot water, bleach, washing up liquid, solvents, paint or stain removers. For stubborn stains use a detergent free soap. Failure
to follow these instructions will result in an invalidated warranty. To dry, hang the open BP1 Protect in a cool, dry, well ventilated
place out of direct sunlight. The BP1 Protect may not be machine washed or dried.
Storage
Never put the BP1 Protect away wet or dirty. This could lead to mould – which can damage the fabrics and cause unpleasant
smells. Store the pack in a cool, dry place out of direct sunlight.
Warranty
Ergon warrants to the original retail purchaser that this product is free from defects in material and workmanship for (2) two years
from the date of original retail purchase. If you have any cause to return the product please take it to a specialist bicycle retailer
together with proof of purchase. The product warranty does not cover modified products, or products used in a way not intended
or set out in this document. Failure to follow all instructions will invalidate the warranty.
Please see the current full warranty policy at www.ergonbike.com/warranty
or scan QR-code for details.
+
Publicité
