Ergon BP1 Protect Mode D'emploi page 15

ERGON BIKE ERGONOMICS
Impact Protector BP100
By opening the Velcro flap on the front you get to the
Protector compartment (Fig. 2). If the protector is to be
replaced – e.g. after a fall – simply pull out the protector
(Fig. 3). Then insert the new protector completely into the
Always read the attached instructions for the
BP100 impact protector.
Please ensure that the
black side of the impact
protector faces the back
of the user.
Fig. 1
Hydration Bladder / Drinking hose
Open the bladder compartment and stow the filled bladder
in the net pocket. Then close the Velcro
to fix the bladder (Fig. 1). Lead the tube
opening of the bladder compartment and along the points
to until led out of the tubing holder (Fig. 2).
6
2
1
Fig. 1
of the security flap
2
out of the upper
3
3
pocket, being sure that it is positioned correctly. Close the
Velcro loop again.
The black side of the impact protector always
faces the wearer's back (Fig. 1).
Fig. 2
When the BP1 Protect is carried underneath the jersey, tighten
the mounting clip of the optionally available Hydrapak
1
Quantum Clip to point
point , and through the neckline of the jersey. Attach the
4 5
magnetic counterpart to the end of the tube. The Hydrapak
4
Elite Quantum Clip ensures a magnetic connection through the
jersey.
Fig. 2
Fig. 3
. Thread the drinking tube through
6
6
5
4
16
EN
Elite
®
®