Publicité
Les langues disponibles
Les langues disponibles
Step 4: Install the Axle/Drive Shaft
a. Slide the Drive shaft through one side of the hopper
frame.
b. Slide gearbox onto axle/drive shaft (make sure
"FRONT" is facing front of frame as shown) and align
middle hole with gearbox.
c. Slide through the other side of the hopper frame.
Assemble M5 x 35mm Hex bolt to Axle/Gearbox and
secure with M5 Nylon Locknut.
Step 5:
Attach non-drive Wheel onto exposed end of Axle and secure with Flat Washer & Cotter Pin. Slide the Flat Washer onto
the Axle until it makes contact with the Wheel, and then slide the Cotter Pin into the hole at the end of the Axle.
Additional Notes:
Drive Shaft: Hole Near Middle should be closer to the right wheel so that the gear box is centered.
Bend
CHAPIN INTERNATIONAL, INC. P.O. BOX 549 700 ELLICOTT ST. BATAVIA, NY 14021-0549 www.chapinmfg.com 800-950-4458
M5 x 35mm Hex bolt
Publicité
